GoToSocial/docs/configuration/httpclient.md

HTTP Client

Settings

################################
##### HTTP CLIENT SETTINGS #####
################################

# Settings for OUTGOING http client connections used by GoToSocial to make
# requests to remote resources (status GETs, media GETs, inbox POSTs, etc).

http-client:

  # Duration. Timeout to use for outgoing HTTP requests. If the timeout
  # is exceeded, the connection to the remote server will be dropped.
  # A value of 0s indicates no timeout: this is not advised!
  # Examples: ["5s", "10s", "0s"]
  # Default: "10s"
  timeout: "10s"

  ########################################
  #### RESERVED IP RANGE EXCEPTIONS ######
  ########################################
  #
  # Explicitly allow or block outgoing dialing within the provided IPv4/v6 CIDR ranges.
  #
  # By default, as a basic security precaution, GoToSocial blocks outgoing dialing within most "special-purpose"
  # IP ranges. However, it may be desirable for admins with more exotic setups (proxies, funky NAT, etc) to
  # explicitly override one or more of these otherwise blocked ranges.
  #
  # Each of the below allow/block config options accepts an array of IPv4 and/or IPv6 CIDR strings.
  # For example, to override the hardcoded block of IPv4 and IPv6 dialing to localhost, set:
  #
  #   allow-ips: ["127.0.0.1/32", "::1/128"].
  #
  # You can also use YAML multi-line arrays to define these, but be diligent with indentation.
  #
  # When dialing, GoToSocial will first check if the destination falls within explicitly allowed IP ranges,
  # then explicitly blocked IP ranges, then the default (hardcoded) blocked IP ranges, returning OK on the
  # first allowed match, not OK on the first blocked match, or just defaulting to OK if nothing is matched.
  #
  # As with all security settings, it is better to start too restrictive and then ease off depending on
  # your use case, than to start too permissive and try to close the stable door after the horse has
  # already bolted. With this in mind:
  # - Don't touch these settings unless you have a good reason to, and only if you know what you're doing.
  # - When adding explicitly allowed exceptions, use the narrowest possible CIDR for your use case.
  #
  # For reserved / special ranges, see:
  # - https://www.iana.org/assignments/iana-ipv4-special-registry/iana-ipv4-special-registry.xhtml
  # - https://www.iana.org/assignments/iana-ipv6-special-registry/iana-ipv6-special-registry.xhtml
  #
  # Both allow-ips and block-ips default to an empty array.
  allow-ips: []
  block-ips: []