j1nx
890a0c80a7
Increase minimal free memory for Raspberry Pis
2021-09-07 13:23:07 +02:00
j1nx
1195968191
Add CONFIG_SND_SOC_TAS5086=m to kernel config
2021-06-07 11:11:13 +02:00
j1nx
f1cda8e142
[WIP] More work on the SJ201 support.
...
Output all ok now
Input still a lot of static noise (trying to figure it out)
2021-05-14 19:46:14 +02:00
j1nx
c2f4db8199
[WIP] More sound architecture changes
2021-05-12 11:26:35 +02:00
j1nx
22389700ba
Remove deprecated elevator= from cmdline.txt
2021-04-06 10:36:04 +02:00
j1nx
96ccec6ddd
Not needed for rpi3 and rpi4 as the watchdog is enabled by default.
...
And as we are not going to support rpi2 and/or lower not needed.
2021-04-02 11:18:54 +02:00
j1nx
d7d2f65e9b
Enable and configure the hardware watchdog.
...
(reboots the device after it hangs for 20 seconds or more)
2021-03-30 13:06:29 +02:00
j1nx
2cc9d46752
Increase initial boot and rootfs partition sizes
2021-03-04 13:20:54 +01:00
j1nx
40d4f26f9f
Increase the default amount of available zram drive slots to 4 (for now)
2021-03-04 11:29:15 +01:00
j1nx
70fa66f615
Add and configure 20% of memory as zram swap with a low agressive swappiness
2021-03-01 21:58:30 +01:00
j1nx
f9ab398d08
Make use of disk identifier
2021-02-12 10:54:20 +01:00
j1nx
17a59feec9
Changes to sound architecture, prepare system no longer needed
2021-02-05 16:10:50 +01:00
j1nx
1d42e2b31f
[WIP] Switch to a Hybrid MBR/GPT partition scheme.
...
- rootfs based on PARTUUID
2021-02-02 20:52:02 +01:00
j1nx
390e3efde6
MycroftOS: Build, install and use the dtbo files from the kernel sources.
...
Instead of the pre-compiled version from the rpi-firmware repository
this to make sute everything is using the same version.
2021-01-30 09:14:05 +01:00
j1nx
640f418648
Revert "MycroftOS: (experimental) respeaker 2mic pulseaudio support."
...
This reverts commit df2ee2d4a5
.
2021-01-29 13:24:27 +01:00
j1nx
6616f3fbc2
[WIP] refactor the mycroft installed skills to buildroot packages.
2021-01-27 22:45:35 +01:00
j1nx
23d303a198
Make sure the default mycroft skills remain git directories
2021-01-17 19:21:22 +01:00
j1nx
c480fc1ee8
Fix stupid overlay mistake for precise
2021-01-17 13:18:48 +01:00
j1nx
d07ca1ede7
Switch precise-engine over to plugin based version
2021-01-10 17:20:54 +01:00
j1nx
68d555fb16
WIP: Implementing all goodies and required changes / dependencies.
2021-01-07 21:21:21 +01:00
j1nx
3eb157a4fa
Change to own pairing skill and make sure MSM doesn't hang on very first boot.
...
Mycroft doesn't continue if the repo skill doesn't get fetched which
obviously can't be fetch without network. So include a local copy
of the skills-repo so at least it doesn't stall the boot.
2021-01-04 20:57:46 +01:00
j1nx
87440d6bc8
Disable wifi power management for wlan0 for rpi
2021-01-03 15:15:49 +01:00
j1nx
1e48bddce4
Create and write proper OS & Machine indentification information.
...
Following the XDG standards;
https://www.freedesktop.org/software/systemd/man/os-release.html
https://www.freedesktop.org/software/systemd/man/machine-info.html
/usr/lib/os-release
NAME="OpenVoiceOS"
VERSION="0.1.0 RaspberryPi 4 64bit"
ID=ovos
VERSION_ID=0.1.0
PRETTY_NAME="OpenVoiceOS 0.1.0 RaspberryPi 4 64bit"
CPE_NAME=cpe:2.3⭕ openvoiceos:ovos:0.1.0:*:development:*:*:*:rpi4-64:*
HOME_URL=https://github.com/OpenVoiceOS/OpenVoiceOS
DOCUMENTATION_URL=https://github.com/OpenVoiceOS/OpenVoiceOS/tree/develop/documentation
SUPPORT_URL=https://github.com/OpenVoiceOS/OpenVoiceOS/issues
VARIANT="OpenVoiceOS - Mycroft Edition"
VARIANT_ID=ovos-rpi4-64-mycroft
/etc/machine-info
CHASSIS=embedded
DEPLOYMENT=development
2020-12-25 12:47:35 +01:00
j1nx
c46e0bfce3
Getting back into OVOS-GUI (Weston) shape + version bumps all over.
2020-12-21 21:23:33 +01:00
j1nx
b5918577bc
Lower the GPU/cmu memory to 64M as we hardly use more then a few MB's
...
This leaves more over for the normal stuff. Especially for the rpi3
2020-10-11 16:23:02 +02:00
j1nx
54f7a418db
Set framebuffer resolution to 800x480
2020-10-11 12:15:40 +02:00
j1nx
cea47b56c2
Start with rebranding to OpenVoiceOS (OVOS).
2020-10-06 21:23:38 +02:00
j1nx
2a1675594e
MycroftOS: Test with resampling everything to 48000
2020-09-18 14:51:30 +02:00
j1nx
c0e74de88e
MycroftOS: Remove old wifi setup files
2020-09-17 15:41:13 +02:00
j1nx
4bda5812a8
MycroftOS: Change nodered.service overlay location
2020-09-15 10:09:32 +02:00
j1nx
baa7435c33
MycroftOS: Add node-red launcher scripts and service file.
2020-09-15 09:37:39 +02:00
j1nx
2838dc9625
MycroftOS: Small changes in default sink/source naming
2020-09-14 16:24:12 +02:00
j1nx
412ca02942
MycroftOS: Changes in sound kernel module handling.
2020-09-03 12:12:03 +02:00
j1nx
a88dc814a6
MycroftOS: Combine all sinks into one and make it the default.
...
This will make the sound being outputted to all sinks, so it should
not matter what you connect. Sound is directed to all available sinks
HDMI and Headphones (and/or usbcards/HATs) both output the same sound.
2020-08-31 19:27:59 +02:00
j1nx
2a059a73dc
MycroftOS: Raspberry Pi config.txt order changes
2020-08-31 12:13:32 +02:00
j1nx
565ea1b00f
Revert "MycroftOS: Build, install and use the dtbo files from the kernel sources."
...
This reverts commit 5a108bea9b
.
2020-08-31 11:57:09 +02:00
j1nx
c8877117a3
MycroftOS: Sound tweaks and fixes
2020-08-31 11:56:20 +02:00
j1nx
ad6133fc35
MycroftOS: Change the kernel module loading order for respeaker as well.
2020-08-30 10:38:11 +02:00
j1nx
df2ee2d4a5
MycroftOS: (experimental) respeaker 2mic pulseaudio support.
2020-08-27 14:11:58 +02:00
j1nx
2d0064f08f
MycroftOS: Split vc4 overlay loading for pi3 and pi4
2020-08-21 10:54:32 +02:00
j1nx
e998a5d76a
MycroftOS: Kernel: Start of own kernel config.
...
(Not used as of yet)
2020-08-04 19:35:51 +02:00
j1nx
5a108bea9b
MycroftOS: Build, install and use the dtbo files from the kernel sources.
...
Instead of the pre-compiled version from the rpi-firmware repository
this to make sute everything is using the same version.
2020-08-04 18:59:41 +02:00
j1nx
49da648bcf
MycroftOS: Remove the noswap restriction from cmdline.txt
...
- RPI3 uses all memory because of the GUI video needs 256
- This together with Precise and only 1GB available is tricky
2020-07-24 10:04:21 +02:00
j1nx
a7c71a0b2b
MycroftOS: use the kms driver instead of the fkms driver.
...
- Need to check if the rpi4 works with this. otherwise a split
in files is needed between the two.
2020-07-23 20:31:10 +02:00
j1nx
684032413f
MycroftOS: Update genimage-raspberrypi3-64.cfg
2020-07-23 19:50:25 +02:00
j1nx
10d5ffb92f
MycroftOS: Add RPI3-64bit GUI config and files.
2020-07-22 10:52:48 +02:00
j1nx
2beaab7a25
MycroftOS: Migrating to new wifi-connect system.
2020-07-21 09:24:45 +02:00
j1nx
f8f60756d6
MycroftOS: Initial start of adding wifi-connect package.
2020-07-20 14:54:23 +02:00
j1nx
f4755b898e
MycroftOS: Fix for new rpi-firmware system (rpi4-64 only for now)
2020-07-20 11:15:34 +02:00
j1nx
08ac7a72d6
MycroftOS: Remove pip binary-only restriction (for now)
2020-07-18 17:25:32 +02:00