• all: bump version to R50-current; add more comments; whitespace
• all: remove all mkssert(); we’ll do full re-runs of scan-build and,
hopefully, Coverity Scan/Prevent
• check.t: fix a testcase (sed could exit false, but we don’t care)
• eval.c: fix tilde_ok data type (only unsigned may shl constantly)
• exec.c: fix shebang buf array accesses to always go via uint8_t *
‣ not like oksh did, but using mksh’s built-in features
• handle suggested __pure additions
• revert cid 1004F7F096867C83CF0
‣ always use our wcwidth code
‣ only use our strlcpy code if none found
• fix a couple of gcc-snapshot and clang/scan-build warnings
• mksh R49~rc1
one set of CTRL, UNCTRL, and new ISCTRL macros) C0 and DEL handling; the
optimisation only works for 7-bit ASCII, so those places 8-bit must pass
intact have an added check
also, while here, remove an editor oops (‘;’), oksh rcsid sync (they did
accept I was right wrt. set -e), int → bool, and code merge/cleanup
Steffen Daode Nurpmeso stumbled upon it and gave very detailed
instructions on how to reproduce it (thanks!); fix that
also only call x_bs0 if xcp < xep because *xep is undefined
prompt display routines; make Emacs and Vi share
code, permitting reducing of duplication and code
removal as well as more consistent behaviour; put
some common code into shared helper functions, too
• New x_adjust() logic (Emacs mode): when determining
what portion of a line to render use a much more
sophisticated algorithm and try to fill up ⅔ of the
total screen width (with line and prompt both) also
as wished from Steffen Daode Nurpmeso
about how and when the display is redrawn by reverting one
bool back to an int, as it’s used as a counter (hm, should
be an unsigned I guess but…)
on the other hand, xlp_valid should’ve been a bool, make it so
expansion completion; problem analysis and solution draft by Andrew
Kudryashov (thanks a lot!); this fix instead re-uses existing code
for solving the problem with multiple matches
debugged using “make d dr” targets, yay!
XXX we could track whether tty_fd has already been successfully opened,
XXX the ttystate initialised, and then just never close it unless it is
XXX necessary, then we can keep COLUMNS/LINES accurate in scripts, even
